User manual

CCTV

Definitions and descriptions of network stream:

Advanced settings are as follows:

Step 1: Enter into MenuÆSetupÆ P.T.Z ÆAdvanced tab. Refer to Fig 4-36:

Step 2: In the Advanced tab, click preset “Setting” button to see a dialog box as Fig 4-37:

Fig 4-36 P.T.Z Configuration-Advanced Fig 4-37 Advanced-Preset

Step 3: In the preset setting tab, while clicking Setting button, a dialog will pop-up as Fig 4-38:

z User can control the dome by rotating up, down, left, right and

adjust the rotating speed zoom, focus and iris of the dome;

z Select the serial number of the preset point. Click

button to

enable the PTZ wiper and click

button to enable the PTZ light.

Fig 4-38 Preset Setting

Note: PTZ must support wiper and light function and these two buttons are just available when selecting PELCOP or PELCOD.

z Click Save button to save the settings, click

icon to hide the

tool bar, right click to view the toolbar again; click

icon to exit the

current interface.

z In the preset interface, click OK button to save the setting; click

Exit button to exit the current interface.

Step4: In the Advanced tab, while clicking cruise “Setting” button, a

dialog box will pop-up as Fig 4-39:

Fig 4-39 Cruise Setting

z Click Add button to add cruise line in the list box (max 8 cruise line can be added); select a cruise line and click Setup

button to see a dialog box as Fig 4-40:

z Click Add icon

to set the speed and time of preset point; select a preset point and then click Delete icon to

delete that preset point; click Modify icon

to modify the setting of a preset point. User can click icons to

adjust the position of preset point. Click Preview button to preview the cruise line; click OK button to save the setting; click Exit

button to exit the current interface.

z Select a preset point in the cruise line list box. Click Delete button to delete that cruise line; click Clear all button to clear all

cruise line from the list box; click OK button to save the setting; click Exit button to exit the current interface.

Step5: In the Advanced tab, while clicking track “Setting” button, a dialog box will pop-up as Fig 4-41:

Parameter Meaning

Address The address of the PTZ device

Baud rate Baud rate of the PTZ device. Range form: 110, 300, 600, 1200, 2400,

4800, 9600, 19200, 34800, 57600, 115200, 230400, 460800, 921600.

Protocol Communication protocol of the PTZ device. Range from: NULL, PELCOP,

PELCOD, LILIN, MINKING, NEON, STAR, VIDO, DSCP, VISCA,

SAMSUNG, RM110, HY, N-control.

Simulative

Cruise

If enabled, no matter whether the PTZ device supports cruise or not, the

presets will cruise.