User manual
78
EN
CCTV
4.7 User Management Configuration
This tab allows you to add normal or advanced users. To add user and setup user authority:
Step 1: Enter into MenuÆSetupÆUser management configuration. Refer to Fig 4-32:
Step 2: Click Add button to display a dialog box as Fig 4-33:
Step 3: In General tab, input username, password and select user type. You can also check ‘Binding PC MAC Address’ and
input this address.
Step 4: Click ‘OK’ button to save settings.
Note: When the default value of binding PC MAC address is 0, the user is not bound with the specified computer. If the bind
option is used, the user would be able to log into the DVR only through the specific computer (carrying the MAC address).
Fig 4-32 User Management Configuration Fig 4-33 Add-General
Step 5: Select Authority tab and then assign the operation rights for particular user. Refer to fig 4-34.
Fig 4-34 Add User-Authority
If you want to delete the user, please select the user you want to delete in the user list box and then click “Delete” button.
If you want to modify the user, please select the user you want to modify in the user list box and then click “Setup” button to
modify its general information and authority.
If you want to change password of a user, please select the user in the user list box and then click “Change Password” button.
4.8 P.T.Z Configuration
P.T.Z configuration includes two submenus: serial port and advanced settings.
Serial port settings are as follows:
Step 1: Enter into MenuÆSetup Æ P.T.Z ÆSerial port tab. Refer to Fig 4-35:
Step 2: Select “enable” and setup the value of address, baud rate and protocol according to the settings of the speed dome.
Step 3: Configure all channels with the same parameters by selecting the “All” box and then doing the relevant setup.
Fig 4-35 P.T.Z Configuration-Serial Port