User manual

76
EN
CCTV
Step 4: No matter what kinds of way to connect internet, you should test the effectiveness of the network by clicking “Test”
button after you setup the network.
Step 5: If the network is well connected, please click “Apply” button to save settings.
4.6.2 Sub-stream
Step 1: Enter into MenuÆSetupÆNetwork ÆSub-stream tab. Refer to Fig 4-28:
Step 2: Select fps, resolution, quality, encode and max bit rate
Step 3: Select “All” to set the same settings for all channels.
Fig 4-28 Network Sub-stream
4.6.3 Email
Step 1: Enter into MenuÆSetupÆNetworkÆEmail tab. Refer to Fig 4-29:
SMTP Server/Port: The name and port number of SMTP server. Check the SSL
checkbox if the server requires a secure connection (SSL); user can setup mail
servers (such as Gmail) as required.
Send address/password: Sender’s email address/password
Receive address: Receiver’s email address. Here user can add at least three mail
addresses. Click TEST button to test the validity of the mailbox.
Attaching image: After selecting it, the system will attach images when sending
the emails.
Fig 4-29 Network Configuration-Email
4.6.4 Server
This function is mainly used for connecting ECMS. The setting steps are as
follows:
Step 1: In the server tab, select “enable” as shown in the Fig 4-30.
Step 2: Check the IP address and port of the transfer media server in the
ECMS. The default server port for auto report is 2009. If it is modified, please
enter into the transfer media interface to check.
Step 3: Enable the auto report in the ECMS when adding a new device.
Then input the remaining information of the device in the ECMS. Fig 4-30 Network Configuration-Server
After that, the system will auto allot a Device ID. Please check it in the ECMS.
Step 4: Input the above-mentioned server IP, server port and device ID in the server interface .Then click “Apply” button to save
settings. Now, the ECMS system will automatically connect this device.
4.6.5 Other Settings
If your DVR is setup to use PPPoE as its default network connection, you may
setup DDNS to be used in connection. The setting steps are as follows:
Step 1: Select Other Settings tab. Enable DDNS server.
Step2: Select DDNS server.
Step 3: Input user name, password and host domain name registered in the DNS
website (See the following example).
Step 4: Click TEST to test the effectiveness of the relevant information.
Step 5: Click “Apply” button to save the settings.
Fig 4-31 Other Settings
Parameter Meaning
FPS
Range from: 1-6 (PAL)
Resolution
Support CIF
Quality
The higher the value is, the clearer the
record image. Six options: lowest, lower,
low, medium, higher and highest.
Encode
VBR and CBR
Max Bitrate
Range from: 256kbps~1792kbps