User manual

74
EN
CCTV
Email: If you select this option, the DVR will send an email alert to the
preconfigured email address in case of a sensor based alarm from the
particular input.
Snap: If selected, the system will snap images of the checked channels on
an alarm and save them in the HDD automatically.
Step 7: Enter into To Record tab. Select recoding channels. It would be
recorded in case of an alarm. Click OK button to save the setting.
Step 8: Enter into To PTZ tab. Set preset, cruise and track options for a
PTZ in case of a sensor based alarm. Single or multiple PTZ units could be
programmed to perform this function on the same alarm.
Step9: Enter into Schedule tab. Refer to Fig 4-20. The setup steps for schedule Fig 4-20 Sensor-Schedule
for sensor based alarm are similar to normal schedule setup.
You can refer to Chapter 4.4.1 Schedule for more details. This step is very important for sensor alarm. Even if you have
enabled the sensor alarm for all channels and setup the trigger, you will not see the result of sensor alarm if no schedule is
added. If you have set the schedule for senor based recording in the same timeline, recordings can also be triggered.
4.5.2 Motion
Motion includes two sub menus: motion and schedule.
The steps to set up motion alarm are as follows:
Step1: Enter into MenuÆSetupÆAlarmÆMotion tab. Refer to Fig 4-21:
Step2: Enable motion alarm, set alarm hold time which refers to the time till
which the system will wait for further detection of motion.
Eg: If the holding time is set to 10 seconds, once the system detects a
motion, it will go into alarm but would not detect any other motion alarm
(specific to channel) until 30 seconds. If there is other motion detected
during this period, it is considered it as continuous movement; otherwise
it will be considered as a single motion. Fig 4-21 Alarm Configuration-Motion
Step3: The setup steps of motion trigger are similar to ‘Alarm Handling’. You
can refer to Chapter 4.5.1 Sensor ÆAlarm Handling for more details.
Step4: Click “Setting” button under the Area to display the following picture
as shown in Fig 4-22:
Step5: In the Area tab, you can drag slide bar to set the sensitivity value
(1-8). The higher the value is the more sensitive it is to motion. Since the
sensitivity is influenced by color and time (day or night), you can adjust its
value according to the practical conditions. Left click the grid and drag to
delete area. Drag again to add area. Click
icon to set the whole area as
detection area. Click
icon to clear the set detection area. Click icon
to test the sensitivity as per the local conditions. Once motion is sensed, it
displays a figure icon. Click
icon to save the setting. Fig 4-22 Motion-Area
Click
icon to exit the current interface.
Note: Prior to setting motion detection field it is recommended that you click
icon to clear the existing field and set afresh.
Step6: Select “All” to setup all channels with the same parameters.
Step7: Click “Apply” button to save the setting.
Step 8: Enter into Schedule tab. The setup steps for schedule for motion
based alarm are similar to normal schedule setup; you can refer to 4.4.1
Schedule for details. This step is very important for motion based alarm.
Even if you have enabled the motion based alarm for all channels and
setup the trigger, you will not see the result of motion based alarm if no
schedule is added.
If you have set the schedule for senor based recording in the same
timeline, recordings can also be triggered.
Fig 4-23 Motion-Schedule