User manual

73
EN
CCTV
4.4.2 Motion
This tab allows to setup schedule for motion based recording.
Step1: Enter into MenuÆSetupÆScheduleÆMotion tab. Refer to Fig
4-15:
Step2: The setup steps for schedule for motion based recording are
similar to normal schedule setup. You can refer to 4.4.1 Schedule for
details.
Note: The default schedule of motion based recording is 24x7, that is,
the color of schedule settings interface is dark blue. This enables
motion based recording for 24x7. If you want to activate motion based
recording, you must enable motion alarm and setup schedule for Fig 4-15 Schedule Configuration-Motion
motion alarm (Refer to Chapter 4.5.2 Motion Alarm for more details).
4.4.3 Sensor
This tab allows to setup schedule for sensor based recording.
Step1: Enter into MenuÆSetupÆScheduleÆSensor tab. Refer to Fig
4-16:
Step2: The setup steps for schedule for sensor based recording are
similar to normal schedule setup (Refer to 4.4.1 Schedule for details).
Note: The default schedule of sensor based recording is 24x7, that is,
the color of schedule settings interface is dark blue. This enables
sensor based recording for 24x7. If you want to activate sensor based
recording, you must enable sensor alarm and setup schedule for sensor
alarm (Refer to Chapter 4.5.1 for more details).
Fig 4-16 Schedule Configuration-Sensor
4.5 Alarm Configuration
Alarm configuration includes five sub menus: sensor, motion, video loss, other alarm and alarm out.
4.5.1 Sensor
Sensor includes three sub menus: basic, alarm handling and schedule.
Operate the following steps to configure sensor alarm:
Step1: Enter into MenuÆSetupÆAlarmÆSensorÆBasic tab. Refer to Fig
4-17:
Step2: Enable channels by checking the checkboxes beside the desired
channels.
Step 3: Set the alarm type according to triggered alarm type. Two option:
NO and NC.
Step4: Click “Apply” button to save settings.
Step5: Enter into Alarm Handling tab. Refer to Fig 4-18. Fig 4-17 Alarm Configuration-Sensor-Basic
Select hold time and then click Setting button. A dialog box will pop-up as Fig 4-19:
Fig 4-18 Alarm Configuration-Sensor-Alarm Handling Fig 4-19 Alarm Handling-Trigger
Step 6: Enter into alarm tab to select the options to handle alarm.
Buzzer: If selected, the local inbuilt buzzer would be activated on an alarm.
Full screen alarm: If selected, there will pop up the chosen channel on the monitor on an alarm trigger.
To alarm out: If selected, this would trigger the external relay output on detecting a sensor based alarm.