User manual

70
EN
CCTV
4.2 Live Configuration
Live configuration includes three submenus: live, main monitor and mask.
4.2.1 Live
In this tab, user can setup camera name.
Step1: Enter into MenuÆSetupÆLiveÆLive tab. Refer to Fig 4-6:
Note: A soft keyboard will pop up by clicking the camera name. User can
self-define the camera name.
Step2: Checkmark the Show Name when you set your camera name.
Click “Default” button to restore the default setting, click “OK” button to save the
setting.
Step3: Select “All” to setup the same settings for all channels.
Fig 4-6 Live Configuration-Live
4.2.2 Main Monitor
Step1: Enter into MenuÆSetupÆLiveÆMain Monitor tab. Refer to Fig 4-7:
Step2: Select split mode: 1×1, 2×2 and channel. Click
button to setup the
previous channel group. Click
button to set the latter channel group.
Step3: Set the dwell time.
Step4: Click “Default” to restore default setting; click “Apply” to save the setting;
click “Exit” to exit the current tab.
Fig 4-7 Live Configuration-Main Monitor
4.2.3 Mask
You can setup private mask area on the live image picture. For a given channel a maximum of three areas can be masked.
Setup mask area: click setting button, enter into live image to press left mouse and drag mouse to set mask area. Please refer
to the below picture. Right click to exit. Click apply button to save the setting.
Delete mask area: select a certain mask area and double click to delete that mask area. Then click apply button to save the
setting.
Fig 4-8 Live Configuration-Mask
Setup Mask Area Live Image Mask Area