User manual

69
EN
CCTV
4.1 Basic Configuration
Basic configuration includes three sub menus: system, date & time and DST.
4.1.1 System
Step1: Enter into MenuÆSetupÆBasicÆSystem. Refer to Fig 4-3:
Step2: In this tab you can setup the device name, device ID, video format, max network user, VGA resolution and language.
The definitions for every parameters display as below:
Device Name: The name of the device as it may display on the client end or on CMS, this would help the user to recognize the
device remotely.
Device ID: This ID is used to map the DVR with IR remote controller and speed dome cameras.
Video Format: Two modes: PAL and NTSC. User can select the video format according to the cameras being used.
Password Check: If enabled the user would need to input the user name and the password for performing corresponding
operations.
Fig 4-3 Basic Configuration-Basic
Show System Time: If selected, displays the current time during live monitoring.
Max Online Users: To set the maximum number of concurrent user logins in the DVR.
Show wizard: If selected, the GUI would launch the startup wizard on every boot, allowing the user to do basic setup.
Video output: The resolution of live display interface, ranges from: VGA800*600, VGA1280*1024 and HDMI.
Note: Switching between VGA and HDMI will change the menu output mode. Please connect to relevant monitor.
Language: To setup the menu language.
Note: After changing the language and video output, the device needs to login again.
Logout After (Minutes): You can setup the screen interval time (30s, 60s, 180s, 300s). If there is no any operation within the
setting period, the device will auto logout and return to the login interface.
No Image When Logout: If selected, there will be no image showing when logout.
4.1.2 Date & Time
Step1: Enter into MenuÆSetupÆBasicÆDate & Time tab. Refer to Fig 4-4:
Step2: Set the date format, time format, time zone in this interface; checkmark
“sync time with NTP server” to refresh NTP server date; user can also adjust system
date manually.
Step3: Click “Apply” button to save the setting; click “Exit” button to exit the current interface.
Fig 4-4 Basic Configuration-Date &Time
4.1.3 DST
Step1: Enter into MenuÆSetupÆBasicÆDST tab. Refer to Fig 4-5:
Step2: In this interface, enable daylight saving time, time offset, mode, start & end
month/week/date, etc.
Step3: Click “Default” button to restore default setting; click “Apply” button to save the
setting; click “Exit” button to exit the current interface.
Fig 4-5 Basic Configuration-DST