User manual

105
EN
CCTV
Fig 8-1 Fig 8-2
Q9: DVR displays “please wait…”all the time
a. HDD power cable and data cable may not be well connected. Please check the connections for HDD.
b. It is also possible that the DVR was forced to stop because HDD has a bad sector and it may have caused the system to halt.
Check with a good known HDD or try formatting the existing HDD.
Q10: How to input password and numbers in the interface?
Click the password or the input box a small keyboard will pop up. Please select characters to be input (the initial password is
123456), or you can use the digital keys on the front panel, or the digital keys on the remote controller.
Q11: A hard disk is being identified as a new device however it was being used with another DVR of same model.
Should it be formatted prior use?
It is possible to migrate an HDD from one DVR to another provided that the DVRs are of the same model and that the HDD
being migrated would be used as the sole disk in the new DVR. However in cases where the new DVR already contains a
HDD, the migrated disk being installed would have to be formatted. In general migrating disks from one DVR to another is not
recommended.
Q12: What is the minimum configuration required for remote monitoring?
PC Module Parameters
CPU Intel Celeron 2.4G
Motherboard Intel 845
HDD 80G
RAM 512M
VGA
NVIDIA GeForce MX440/FX5200
ATIRADEON 7500/X300
OS Windows 2000(SP4 above) /Windows XP(SP2 above) /VISTA
DirectX 9.0
Q13: How to handle the situation that the codec Control is blocked when downloading in the VISTA or Win7 system?
This problem can be fixed in two ways:
c. Enter Control PanelÆUser Account and Family Safety Æ User Account Control (refer to Fig 14-1); click Turn User Account
on or off. Cancel Use User Account Control (UAC) to help protect your computer.
d. Right click IE browser (refer to Fig 14-2), select Run as administrator to run browser.