User Manual

1. Button function:

1. “40°C”: The temperature setting is 40°C

after pressing this button.

2. “70°C”: The temperature setting is 70°C

after pressing this button.

3. “85°C”: The temperature setting is 85°C

after pressing this button.

4. “100°C”: The water will be heated up to

boiling after pressing this button.

5. “START/STOP”: Start/shutoff the unit.

6. “KEEP WARM”: Start or stop the KEEP

warm.

2. Description of operation

Preparation: place the kettle on a ﬂat and level table and plug in accordingly. Fill the

kettle with enough water (the water level must not be lower than the MIN mark or higher

than the MAX mark).

The appliance will carry out a self-check routine and give an audible signal. It will then

go into standby mode.

Standby mode: press one of the buttons to set the temperature. Then press the “START/

STOP” to start heating. The appliance will give an audible alarm when it has reached the

set temperature and will enter standby mode automatically.

When you press “START/STOP” in standby mode the appliance will heat the water to the

last temperature setting you selected. If the unit is unplugged and then plugged back

in, it will enter standby mode. If you press “START/STOP” now, the default temperature

setting will be 100°C (Boil).

Press “KEEP WARM” in standby mode to start the keep warm function. Press “KEEP

WARM” again to shut off. When the appliance is in KEEP WARM mode you can press

“START/STOP” to start heating. When it reaches the set temperature, the appliance will

enter KEEP WARM mode automatically.

WARNING: Do not remove the lid while the water is

boiling.

CAUTION: Position the lid so that steam is directed

away from the handle.

CAUTION: Insure that the appliance is switched off

before removing it from its stand.

Button display