User Manual

14
FUNCTION
SETUP MENU
This menu sets the functions for the four function buttons on the top
of the monitor.
Available functions:
AUDIO METERS
1
Displays left- and right-channel audio meters on-screen. Position
options are top, left, division, right, and bottom. The default setting
is top.
5D II REC
Scales the video output to t the screen when recording with a 5D
Mark II DSLR camera.
PIXEL TO PIXEL
1
Pixel-to-Pixel mode turns off scaling and displays the incoming video
signal in its native resolution and aspect ratio with 1:1 pixel mapping.
If the picture is larger than the monitor’s 1920 × 1080 resolution, the
center of the image will appear on-screen.
HDR (HLG)
Turn on Hybrid Log-Gamma (HLG) format to correctly display the
entire dynamic range of an incoming HDR signal that utilizes the
Hybrid Log-Gamma luminance map. The HDR (HLG) function can be
used with any applied LUT. Options are on or off. The default setting
is on.
BRIGHTNESS
2
Adjusts the monitor’s brightness value from 0–100. The default
setting is 50.
CONTRAST
2
Adjusts the contrast value of the on-screen image from 0–100. The
default setting is 50.
CHROMA
2
Adjusts the saturation of the on-screen image. The default setting is
50.
SHARPNESS
2
Adjusts the value of ne detail of the picture from 1–100. The default
setting is 30.
TINT
2
Adjusts the tint value from 0–100. The default setting is 50.
COLOR TEMPERATURE
2
Adjusts the color temperature of the on-screen image. Presets are
5600, 6500 (default), 7500, 9300, and Manual. When User mode is
selected, the values of red, green, and blue can be set manually from
0–255. Red, green, and blue are preset to 128.
ASPECT
2
Adjusts the aspect ratio of the incoming video signal and how it is
displayed on-screen. Options are User, 16:9 (default), 15:9, 1.33:1, 1.5:1,
1.85:1, 2:1, 2.35:1.
BACKLIGHT
2
Adjusts the intensity of the backlight. Options are low, middle, and
high. The default setting is high.
CAMERA CONTROL
1
This displays on-screen controls for the selected camera type. Camera
options are Canon (default), Sony, Panasonic, BMPCC, Remote, and Z
CAM E2. Position options are right (default) and left. The Update USB
option allows you to upgrade the rmware of your camera control
device using the included USB drive. For more information, see
Camera Control Functions below.
DISPLAY FLIP
Flips the on-screen image along the horizontal axis.
OSD FLIP
Flips the on-screen display and menus along the horizontal axis.
CHECK FIELD
3
When Check Field mode is on, only the selected color information
from the incoming video signal will appear on-screen. Check Field
mode is useful for calibrating the monitor. Select between blue, red,
green, mono, and off. The default setting is off.
1
Once the function is assigned to the function button, press and hold the button for 3 seconds to display the function’s menu.
2
Once the function is assigned to the function button, press the button, and then use the scroll wheel to adjust the parameters.
3
Once the function is assigned to the function button, press the button repeatedly to cycle through the function options.