User Manual

MOUNTING THE MONITOR ONTO A CAMERA

1. Determine the monitor orientation you prefer, and screw

the ballhead into the bottom or side 1/4-20 threaded socket

until it’s tight.

2. Loosen the mounting foot by turning the locking wheel

clockwise. Make sure the side tilt adjustment knob is tight,

and the ballhead is locked in place.

3. Fully insert the foot into the camera’s shoe, and tighten the

locking wheel by turning it counterclockwise until secure.

4. Adjust the monitor angle by holding onto it while loosening

the adjustment knob. Change the monitor’s position, and

tighten the tilt adjustment knob until the monitor does not

slip.

MOUNTING THE MONITOR TO A CAMERA RIG

To mount the ballhead directly to an accessory with 1/4-20

mounting sockets, like a shoulder rig or slider, follow these

steps:

1. Tighten the ballhead’s tilt

adjustment knob, and then

remove the mounting foot

by unscrewing it.