User`s manual

Threading The

Optional Label

Dispenser

If your printer is equipped with the optional Label

Dispenser (PSAT or PSET) and you would like

the printer to automatically peel adhesive labels

from the backing, follow the steps below:

Step ➊ Perform steps 1-4 of the Loading Labels proce

dure.

Step ➋ Peel the first two labels off the backing.

Step ➌ While pressing the FEED switch, push the label

backing into the peeler slot.

Step ➍ Open the print carriage and pull the label backing

out the bottom slot until it is tight across the peeler

bar. Close and lock the print carriage.

Activate the Label Taken Sensor by pressing in

on the top of the sensor.

980101-001 Rev. A

Operation