User`s manual

AutoSense Gap
Sensor
Adjustment
To activate the AutoSense feature, first place
the power switch in the OFF (0) position. Load
labels into the printer (do not use the
dispenser), then press and hold the FEED
Control while placing the power switch
in the ON (1) position. Release the FEED
Control when the printer starts feeding labels.
The printer will advance 3-4 labels while
performing the adjustment. When the
adjustment is complete, a status summary label
will be printed and the printer will be placed in
Diagnostic Dump mode. Tap the FEED
Control once to switch the printer back to
normal operation. If the indicator continues to
glow ORANGE or switches to RED, refer to
Appendix A for troubleshooting information.
980101-001 Rev. A 19
Operation
Dump Mode
Sample Printout