User manual

DC Controller
UPC4 Master
User Manual
Page 91/100
©2010. ELTEK VALERE DEUTSCHLAND GmbH. UM_UPC4_V2.00_E_R1.1_2011-01-04
3067 Capacity low A s. Capacity Calc. This event is active if the capacity of the batteries of
system [1] which is calculated by the capacity
calculator is less than threshold A (%). This signal is a
warning signal.
3068 Capacity low B s. Capacity Calc. Detail s. Event no. 3067
3070 Tsensor lim Batt This event is active if one of the battery
temperatures of system [1] has a value less than -50
°C or greater than +150 °C. At measuring value
assignment the measuring source parameter must
not be "0" (UNDEFINED). The related battery
temperature measurement must be enabled.
3073 diesel operation s. Charge control Diesel operation is active. This event status is taken
in consideration at "Charge control" and "boost
charge" as well.
3075 STS: Error state STS signals error
3076 STS: No CAN see CAN devices STS has lost the CAN connection
3077 STS Err source 1 STS source 1 error
3078 STS Err source 2 STS source 2 error
3079 STS Sync error STS synchronization error
3080 STS Inverter err STS signals inverter error
3081 STS T. heat sink STS temperature to high
3082 STS Current high STS current to high
3083 STS DC volt. low STS DC voltage is low
3084 STS DC volt.high STS DC voltage is high
3085 STS DC v. low Wa STS warning DC voltage is low
3086 STS DC v.high Wa STS warning DC voltage is high
3087 STS Mains prior. STS mains priority
3088 STS Relay active STS Relay is active
3089 STS Load on INV STS Load on inverter(s)
3090 STS Coll. alarm STS collective alarm is active