Specifications

Chapter 8 – PL Smart Transceiver Programming
212 PL 3120/PL 3150/ PL 3170 Power Line Smart Transceiver Data Boo
k
PL Smart Transceiver Channel Definitions
The appropriate standard transceiver type (PL-20N, PL-20C, PL-20N-LOW, PL-20C-LOW, PL-20A or PL-20A-LOW)
is selected on the NodeBuilder Hardware Template Properties page, as shown in the figure below:
.
Figure 8.1 Choosing the Standard Transceiver Type in NodeBuilder Tool
PL Smart Transceiver Clock Speed Selection
When operating in A-band the PL Smart Transceiver uses a 6.5536MHz crystal and thus a clock speed of 6.5536MHz
must be selected on the NodeBuilder Hardware Template Properties page as shown on the left of Figure 8.2. For C-band
operation where a 10MHz crystal is used a clock speed of 10MHz must be selected as shown on the right of Figure 8.2.
Figure 8.2 Choosing the Clock Speed in NodeBuilder