Specifications

USER’S HANDBOOK
CAUTION: BE CAREFUL WITH OLD BATTERY. DO NOT PUNCTURE NOR PUT THEM IN A FIRE NOR
TRY TO CHARGE NOR DISASSEMBLE THEM.THEY COULD SPLIT AND/OR EXPLODE.
DANGEROUS SUBSTANCE MAY LEAK. DO NOT THROW THEM AWAY. FOLLOW THE
INSTRUCTIONS GIVEN BY THE BATTERY MANUFACTURER AND FOLLOW LOCAL
DISCARDING RULES
B. CodADT tool
-
Move the switch to OFF,
- Disconnect the CodADT tool from test interface device,
- Open the battery compartment on the side of the CodADT tool by pulling with a screwdriver,
- Remove the old battery and place the new with keeping the good polarity
C. Test Interface Device (Ref. Fig 55):
-
Disconnect the Test Interface Device connectors.
- Open the plastic box using a screwdriver blade inserted in the holes on the sides of the box.
- Disconnect the two battery wires (3) from the terminal strip located on the Test Interface Device
board (1), using a screwdriver.
CAUTION:
DO NOT SHORT CIRCUIT THE TWO DISCONNECTED WIRES.
- Remove the battery (3) from the bottom part of the box.
- Fit the new battery (3) in the box.
- Re connect the two wires to the terminal strip (2).
CAUTION
: DO NOT SHORT CIRCUIT THE TWO WIRES WHEN MAKING THE CONNECTION.
MAKE SURE THAT THE TWO WIRES ARE CONNECTED IN THE RIGHT DIRECTION.
- Close the box.
- Charge the unit.
Page 86
Mar
. 08/12