Specifications

USER’S HANDBOOK
1
Beacon ID verification
To perform this task the ELT transmitter or Programming Box or CodADT tool must be connected to
the Test Interface Device PROG connector on one side with the relevant encoding cable:
 For the Programming Box (Prog. Box) of the ELT model A06V2, use the P/N 96N9028 cable,
Note: Connect the Jaeger connector only to the Programming Box side and connect the
other end to the PROG. Connector (Test Interface Device side) when the software asks
to “Turn ON the beacon”.
 For the A06V2 ELT transmitter, connect the P/N 96N9029 extension cable with the P/N 96N9028
cable. They are connected to the TC connector (ELT side) and to the PROG connector (Test
Interface Device side),
 For the ADT406 ELT or CodADT tool, use the P/N 02N65746 cable connected to the ELT
REMOTE CONTROL connector (ELT side) and to the PROG connector (Test Interface Device
side),
Note: the software automatically detects the CodADT tool.
 For the A06 or A06V1 or A06T or S06 ELT, use the P/N 93N6222 cable connected to the TC
connector (ELT side) and to the PROG connector (Test Interface Device side),
Click R
ead. The screen instructs the Operator to turn ON the ELT.
st
graph will display the data transfer, then the screen instructs the Operator to turn OFF the
ELT.
Turn ON the ELT or the CodADT tool or connect the programming cable (P/N 96N9028) to the Te
Interface Device when using the Programming Box of the A06V2 ELT.
A bar
Page 37
Mar
. 08/12