Specifications

USER’S HANDBOOK
(2) USB / RS232 driver (STB-06-A software recovery only)
The use of an USB / RS232 adapter is necessary with a portable computer only equipped with USB
port.
This USB / RS232 adapter require a driver initially installed by ELTA at the same time as STB-06-A
s
oftware. .
This driver must be reinstalled in the event of complete computer software recovery.
Use the CDROM supplied with the USB/SERIAL interface and follow the instructions given by the
USB/SERIAL interface manufacturer.
(3)Decimal symbol configuration verification
IMPORTANT
:
For correct access to « spec.ini » information it is important to verify that the PC operating system is
set correctly with the decimal symbol. It should be set to dot « . » and not to coma « , ».
If not, the content of “spec.ini” will not be taken into account and software default values will apply.
On standard PC computer, access the decimal symbol configuration as indicated here under
“Control Panel
-> Date, Time, Language, and Regional Options
-> Regional and Language Options
-> Regional Options (English?)
-> Customize….
-> Numbers
-> Decimal symbol & verify it is duly “. “ (dot)
(4)For correct test reports prints, check WordPad configuration (page margins)
Test reports created by STB06 software under directory « save » can be read directly with Wordpad
(recommended), do not use Word as it will incorporate controls characters).
Using standard configuration of Wordpad may cause paging failure (report not correctly presented on
one single page, (format trouble)
Solving this issue is simple, it just need you to modify Wordpad configuration.
To do so open Wordpad then
Open this
function
Page 29
Mar
. 08/12