Specifications

USER’S HANDBOOK
Page 24
Mar. 08/12
(2) Putting test bench into service
When the test bench is used in autonomous mode, do not perform the procedure described below
but go straight to paragraph (b) Switching on the computer
(a)Connect the test bench to the power supply
- Take the External Power supply adapter out of the case. Connect it to the External Power
supply and to the DC connector input of the computer.
- Connect the Test Interface Device External Power supply adapter to the External Power Supply
and to DC 12V IN connector of the Test Interface Device.
- Indicator of the Test Interface Device becomes red (battery charging in progress).
(b)Switching ON the portable computer (STB-06-A only).
- Power the portable computer by pressing the push-button at the topside of the keyboard. After
a few seconds, the computer screen comes on.
- A MICROSOFT welcome screen, then a "Windows XP" page is displayed. Wait until the STB-
06-A icon is displayed and follow instructions displayed on screen.
Note: Normally the STB-06-A software is launched automatically. If not then double click on
the STB-06 icon on the screen.
Note: For STB-06-LA software application, double click on the STB-06 icon on the screen.