User's Manual

2.4 GHz Communications Option Board
Installation Guide
Elster Integrated Solutions, LLC 12/3/2008
208 South Rogers Lane
Raleigh, NC 27610
[phone]
Fax [phone] of 8
1.2.3. Labeling
If the FCC ID is not visible when the module is installed inside another device, then the
outside of the device into which the module is installed must also display a label referring to
the enclosed module. This exterior label can use wording such as the following: “Contains
Transmitter Module FCC ID: G8J ZGB1” or “Contains FCC ID: G8J ZGB1.” Any similar
wording that expresses the same meaning may be used. The Grantee may either provide
such a label, an example of which must be included in the application for equipment
authorization, or, must provide adequate instructions along with the module which explain this
requirement. In the latter case, a copy of these instructions must be included in the
application for equipment authorization.
1.2.4. RF Exposure
A separation distance of at least 20cm from the end user is required.
1.2.5. Co-Located Transmitters
Provisions have been provided on the Interface Connector such that this device will be
disabled if another co-located transmitter is required to transmit.
This device “may not” be operated as a co-located transmitter with other transmitting devices
unless certification is obtained as a new end product.
1.2.6. Additional Testing
Users incorporating this device into their product must test the complete system, with radio
module installed, against the appropriate standard for the host device.
While the applicant for a device into which an authorized module is installed is not required to
obtain a new authorization for the module, this does not preclude the possibility that some
other form of authorization or testing may be required for the device.