User's Manual

APPENDIX
VRT Gas Transponder ― User Guide Page 39
AMCO Automated Systems • P/N 52870T010 Rev 1 May 2003
Daylight Savings Time
The transponder can be set to switch between daylight savings time
and standard time. To do this, however, the transponder must be
told when Daylight Savings Time starts and ends.
The table below shows the dates (through the year 2030) when
Daylight Savings Time begins and ends.
Next Daylight Savings Time Start Date
The transponder’s internal clock will automatically switch to daylight
savings time on the date represented by the value entered into this
field.
The value must represent a future date. Please refer to table
[TABLE 02] for a list of valid entries.
This value is programmed at the factory for the next valid date after
it is shipped, but must be updated by the utility for subsequent
periods.
Next Daylight Savings Time End Date
The transponder’s internal clock will automatically switch to
standard time on the date represented by the value entered into this
field.
The value must represent a future date.
Please refer to table [TABLE 2] for a list of valid entries.
This value is programmed at the factory for the next valid date after
it is shipped, but must be updated by the utility for subsequent
periods.