User's Manual

CHAPTER 6 VRT REMOTE GAS-METER TRANSPONDER INSTALLATION
VRT Gas Transponder ― User Guide Page 33
AMCO Automated Systems • P/N 52870T010 Rev 1 May 2003
5. Secure slide screws into position.
• You may be able to finger-tighten these sufficiently, but it is
recommended you use either an adjustable wrench or a
3/16
ths
English socket to secure the slide.
6. Mount the transponder to meter in desired location.
• Use the 2 slotted screws previously removed from the
meter.
• Do not over-tighten screws.
7. Dress pulser cable neatly.
• Tie up or bind any excess cable and position it out of harm’s
way.
8. Program the transponder to the reading on the index.
• Refer to the programming procedure at the end of this
chapter for specific instructions.
VRT RGT Mounting (Wall-mount)
Tools, Equipment and Materials
For this part of the installation you will need the following:
• Phillips-head mounting screws (2)
• Phillips screwdriver
Meter
slotted
screws