User's Manual

VRT REMOTE GAS-METER TRANSPONDER INSTALLATION CHAPTER 6
Page 28 VRT Gas Transponder ― User Guide
AMCO Automated Systems • P/N 52870T010 Rev 1 May 2003
8. Slide the index/pulser assembly into the index box.
9. Reattach the index/pulser assembly to the index box.
• Use the 2 screws removed in Step 2.
• Ensure that the wires are not pinched anywhere before
tightening screws.
• Verify that the index turns without binding.
Route wires
toward the
notch in the
index box.
Make sure
they’re not
pinched
under posts
or spacers
Notch