User's Manual

CHAPTER 6 VRT REMOTE GAS-METER TRANSPONDER INSTALLATION
VRT Gas Transponder ― User Guide Page 25
AMCO Automated Systems • P/N 52870T010 Rev 1 May 2003
3. Cut a small notch in the base of the index box (on the left side
near the back).
• Use either the nibbling tool or file.
• The notch should be only large enough to allow the
connecting cable to pass through.
CAUTION: The notched index cover should fit snugly over
the cable but not so tightly that the wires inside may be
broken or crimped when the box is tightened down.
4. Place a tall spacer over each of the 2 posts protruding from the
back of the index.
• Use either tall spacer A (1/2”) or B (7/8”) depending upon
the width of the index post. (See illustration below.)
Cut a small
notch on left
side of the
base (near
the back) to
pass cable
though.
Index
posts
Tall
spacers