User's Manual

VRT REMOTE GAS-METER TRANSPONDER OVERVIEW CHAPTER 4
Page 22 VRT Gas Transponder ― User Guide
AMCO Automated Systems • P/N 52870T010 Rev 1 May 2003
Identifying the Components (Wall Mount)
Each shipment of Wall Mount VRT RGT transponders includes all
the hardware necessary to successfully install a transponder onto a
meter.
You will receive:
• The wall-mount transponder
• A 5-ft or 10-ft meter pulser board connected to the transponder
by a standard one-foot cable (longer cable may be special-
ordered with the transponder)
• Six (6) plastic spacers (2 short, 2 tall/fat post, 2 tall/thin post) to
position the pulser board on the index
• Two Phillips-head mounting screws for the wall-mount housing
Wall-mounting hardware can also be purchased separately. See
table below for part numbers.
To Order Additional Wall-mount Hardware
Item Part Number*
Mounting Screws (2) 10502P005
Pulser Mounting Kit (6 spacers) 52807K003
* Part numbers are subject to change. Be sure to include item description when ordering.
Pulser board
(shown:10 ft
meter board)
Spacers (6)
Wall-mount
remote VRT
gas
transponde
r
Mounting
screws
(
2
)