User's Manual

CHAPTER 5 VRT REMOTE GAS-METER TRANSPONDER OVERVIEW
VRT Gas Transponder ― User Guide Page 21
AMCO Automated Systems • P/N 52870T010 Rev 1 May 2003
Identifying the Components (Meter Mount)
Each shipment of VRT RGTs includes all the hardware necessary to
successfully install a transponder onto a meter.
You will receive:
• The meter-mount transponder
• A 5-ft or 10-ft meter pulser board connected to the transponder
by a standard one-foot cable (longer cable may be special-
ordered with the transponder)
• Six (6) plastic spacers (2 short, 2 tall/fat post, 2 tall/thin post) to
position the pulser board on the index
• Meter mounting kit (2 brackets with 2 hex-head slide screws
and 2 Phillips-head screws)
Meter-mounting hardware can also be purchased separately. See
table below for part numbers.
To Order Additional Meter-mount Hardware
Item Part Number
Meter Mounting Kit (2 brackets, 2 mounting
screws, 2 hex slide screws)
52805K004
Pulser Mounting Kit (6 spacers) 52807K003
* Part numbers are subject to change. Be sure to include item description when ordering.
Pulser board
(shown: 5 ft.
meter board)
Mounting kit with:
• brackets (2)
• slide screws (2)
• mounting screws (2)
Spacers (6)
Meter-mount
remote VRT
gas
transponder