User Manual

ASSEMBLING URFI COMPONENTS
Universal RF Interrogator ? Installation Guide Page 14
AMCO Automated Systems • P/N 52845G120 Rev 1 FEB 2004
Connecting Handheld Terminal to URFI
1. Slip the URFI unit into its wearable carrying pouch and snap closed.
• Ensure the serial port, power and antenna ports are properly
exposed through the opening in the fabric.
2. Connect the male end of each antenna coax cable to the
corresponding port on the URFI.
• Transmit antenna connects to the port on the left, receive
antenna on the right.
• Align the coax connector pin with the hole in the center of the
URFI antenna port. Push in and twist until connector locks into
place.
3. Connect the large end of the RS232 serial cable to the serial port.
• Align the connector so that the 4-pin row on the cable aligns with
the 4-hole row on the URFI serial port. Push connector till snug.
• Turn the two locking screws on either side of the connector until
finger tight and the connector is secured to the URFI.
Transmit Antenna Port Receive Antenna Port
RS232 Serial Port Power Port