User Manual

ASSEMBLING URFI COMPONENTS
Universal RF Interrogator ? Installation Guide Page 13
AMCO Automated Systems • P/N 52845G120 Rev 1 FEB 2004
3. Attach the receive antenna (long) to the antenna port on the top right
of the installed bracket.
• Align the antenna connector’s center pin with the center of the
antenna port on the bracket and push antenna connector into
port. Twist until connector locks in place.
4. Connect one end of each coax cable to an antenna port on the right
side of the bracket.
• The transmit
antenna port is nearest the front of the handheld
terminal (top, in the photo below).
• The receive antenna port is toward the back of the handheld
terminal (bottom, in the photo below).
• Align center hole of each coax cable’s female end with the pin in
the center of the antenna port. Push cable connector into port
and twist till the connector locks in place.
5. Connect the round end of the RS232 serial communications cable to
the serial port on the right side of the handheld terminal.
• Align the red dot on the cable connector with the red dot on the
port. Push connector pins into place until snug.
Transmit antenna port
Receive antenna port
RS232 serial port
Red dot on cable end
Red dot on serial port