User Manual

ASSEMBLING URFI COMPONENTS
Universal RF Interrogator ? Installation Guide Page 12
AMCO Automated Systems • P/N 52845G120 Rev 1 FEB 2004
Assembling URFI Components
The URFI/handheld terminal interrogator system will take about five
minutes to assemble using the procedures described below. No special
tools are required.
Connecting Antennas and Handheld Terminal
The URFI system will be shipped with a bracket designed specifically for
your type of handheld terminal. Once connected to the handheld
terminal, this bracket holds the transmit and receive antennas and the
ports for connecting the coax cables from the handheld terminal to the
URFI.
Use the following procedure to connect bracket, antennas and cables to
the handheld terminal:
1. Attach bracket to the top rear of the handheld terminal by using the
hardware provided.
2. Attach the transmit
antenna (short) to the antenna port on the top left
of the installed bracket.
• Align the antenna connector’s center pin with the center of the
antenna port on the bracket and push antenna connector into
port. Twist until connector locks in place.
RS232 connector
(Left side)
Trans mit antenna (short)
A
ntenna coax connectors
(2)
(Right side)
Receive antenna (long)
Antenna bracket
Handheld terminal
(customer-supplied)