User Manual

Unified Field Tool 2
FCC AND INDUSTRY CANADA COMPLIANCE
The 900 and 451.35MHz radio module is manufactured directly onto the
main circuit board, and the module is inserted into the plastic housing that
attaches to the user’s belt using the included beltclip. The Bluetooth
module is a pre-certified module (FCC: PI4411B, IC: 1931B-BTM411). The
UFT has no user-serviceable parts.
User Information (Part 15.105)
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If you experience trouble with this equipment, please use the Return
Material Authorization (RMA) feature available at the Online Customer
Services at www.elstersolutions.com. Do not attempt to repair this
equipment yourself unless you are replacing the entire module.
Compliance Statement (FCC Part 15.19 and Industry Canada)
This device complies with part 15 of the FCC Rules and with Industry
Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation of the device.
Énoncé de conformité
Cet appareil est conforme à la Partie 15 des règles de la FCC et aux CNR
d'Industrie Canada applicables aux appareils radio exempts de licence.
L'utilisation de cet appareil est soumise aux deux conditions suivantes : (1)
Cet appareil ne doit pas provoquer d'interférences nocives et (2) cet
appareil doit accepter toutes les interférences reçues notamment celles
pouvant provoquer un fonctionnement intempestif de l'appareil.
Antenna Compliance
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to
other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent
émetteur radio peut fonctionner avec une antenne d'un type et d'un gain
maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada.
Dans le but de réduire les risques de brouillage radioélectrique à l'intention
des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte
que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas
l'intensité nécessaire à l'établissement d'une communication satisfaisante.
Preliminary