User's Manual

TROUBLESHOOTING CHAPTER 4
Page 18 Short Range Programmer VRT—User Guide
P/N 52806T100 Rev 1 April 2003 • AMCO Automated Systems
Symptom Possible Cause Solution
Upon attempting to read or
program index or pre-divider, SRP
displays “Wild Card Not Valid”
message.
These operations do not allow the Wild
Card option.
Enter serial number manually or obtain serial
number via Find mode.
Upon interrogation, SRP displays
“CS/LOAD ERR” and “TAMPER”
messages.
This occurs normally at first interrogation
after a transponder has been powered
up (either new or reset).
Interrogate again to clear messages.
Upon interrogation, SRP displays
“CKSUM ER” message.
This occurs normally after the second
interrogation of a new or reset
transponder and will remain until
transponder is programmed.
Program transponder.