User's Manual

CHAPTER 3 SRP OPERATION
Short Range Programmer VRT—User Guide Page 15
P/N 52806T100 Rev 1 April 2003 • AMCO Automated Systems
8. If the interrogation is NOT successful, move the SRP to a slightly
different position relative to the transponder (closer, farther away, or
to one side) and interrogate again.
• Radio waves can bounce off of, or be absorbed or deflected by,
various materials (especially metals) which can create slight
differences in signal strength from one spot to another.
Using Read History and TOU Mode (VRT)
Reserved for factory use only.
This mode reads the transponder time-of-use (TOU) accumulators and
history.
NOTE: Should you need to read transponder TOU, Daily History and
other factory-installed defaults using the SRP, contact Customer Service
at AMCO Automated Systems.
Using Set Meter Parameters Mode (VRT)
Reserved for factory use only.
This mode programs the transponder’s date, time and pre-divider.
NOTE: Should you need to reprogram transponder TOU, Daily History
and other factory-installed defaults using the SRP, contact Customer
Service at AMCO Automated Systems.
Using Transponder TX Test Mode
Reserved for factory use only.
NOTE: This is an in-shop transponder transmitter diagnostic tool used by
the manufacturer.