Installation Instructions

ManualsBrandsElster Solutions ManualsElectronicsSNREM Printed Circuit Board Assembly

Gas 4.0 module

Installation instructions

IL42-5015C

INTRODUCTION

The gas module is designed for use with most residential diaphragm gas meters. Modules for residential meters are available in

three distinct types:

• Type A: American Meter Company products

• Type R & R415: Rockwell, Equimeter, Invensys®

• Type S: Sprague, Schlumberger, Actaris, Metris®

TOOLS, EQUIPMENT AND MATERIALS

All or some of the following items may be needed in order to install the module, depending upon the type of meter/index and the

condition of the old index cover and gaskets:

• Gas module

• Connexo FieldSense Installer

• Index screws (2 each)

• Meter mounting bolts (3 or 4 each, depending upon the meter type, supplied with the module)

• Index cover (if old one is not reusable)

• Index cover gasket (supplied with the module)

• Putty knife or scraper to remove old gaskets

• #2 Phillips screwdriver

• Awl to remove existing tamper seals

• Tamper seals (2 each, supplied with the module)

• Pressure compensation factor value, if needed (obtain from Honeywell Smart Energy)

PREPARATION

Before removing the existing index and index cover, make sure that the module style is compatible with the meter style.

Preliminary

Summary of content (6 pages)

PAGE 1
Preliminary Gas 4.0 module Installation instructions IL42-5015C INTRODUCTION The gas module is designed for use with most residential diaphragm gas meters.
PAGE 2
Preliminary Figure 1. Gas module for Type A index Battery side Front side INSTALLING THE INDEX 1 Remove the existing index cover and index (or module) from the meter. Use an awl to remove the existing tamper seals. 2 Clean any debris from the index and cover. 3 Using a scraper or putty knife, remove the gasket and any adhesive material from the meter. 4 Align the index wriggler with the module wriggler (battery side), as shown below.
PAGE 3
Preliminary 5 Attach the index to the module using the appropriate index screws. Do not over tighten the screws. Index assembly Gas module Index screws Meter mounting bolts Index cover Tamper seals CHECKING MECHANICAL OPERATION This procedure will make sure the attached index rotates freely and without resistance. 1 Rotate the index drive dial clockwise 3 times.
PAGE 4
Preliminary 4 While holding the assembly against the meter, gently try to turn the drive wheel clockwise and then counterclockwise. - If the drive wheel meets resistance in both directions, it is properly mated. Continue withStep 5. - If it meets no resistance in either direction & can freely rotate 360 degrees, then make sure the meter is completely free of old gasket material then forcefully press the module on to the meter. Repeat Step 4.
PAGE 5
Preliminary FCC & Innovation, Science and Economic Development Canada compliance The radio module is inserted into the housing of the device at manufacture. It has no user serviceable parts. User Information (Part 15.105): This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 6
Preliminary NOTES: DISCLAIMER OF WARRANTIES AND LIMITATIONS OF LIABILITY There are no understandings, agreements, representations, or warranties either express or implied, including warranties of merchantability or fitness for a particular purpose, other than those specifically set out by any existing contract between the parties. Any such contract states the entire obligation of the seller.