Installation Instructions

Water 4.0 module 3 IL42-5050B

3 Reattach the remote mount cover to the Honeywell Water 4.0 module.

4 Hang the Honeywell Water 4.0 module on the hanger screw, making sure it is level.

5 Screw 2 screws into the 2 bottom supporting screw mounts.

6 Using the table in “Connection instructions” on page 1, connect the appropriate wires to the correct terminals on the water

meter register. Typically, the connection is made by placing the wire under the screw terminal and tightening down securely.

See the product documentation for your water meter register for more information.

7 When you have completed the installation, secure the Honeywell Water 4.0 enclosure by inserting the tamper plugs into

bottom supporting screw mounts.

PIPE MOUNT

The Honeywell Water 4.0 module can be mounted on a pipe close to the water meter. The pipe mounting option uses a hose

clamp and mounting bracket to attach the Honeywell Water 4.0module to a pipe.

The cable from the Honeywell Water 4.0 module to the water meter register should not exceed 100 feet (30 meters).

1 Remove the remote mount cover from the Honeywell Water 4.0 module.

2 Align the mounting bracket to the remote mount cover and secure the mounting bracket with screws.

CAUTION

Be sure to connect the cables correctly. Failing to properly connect the cables may prevent the module from installing

correctly. For information on proper connections, see “Connection instructions” on page 1.

3 For proper operation of the module, connect the cables as described in “Connection instructions” on page 1.

- If you do not have an inline connector, splice the cables from the Honeywell Water 4.0 module to the water meter

directions for wire preparation when using gel caps.

Insert the cable back into the Honeywell Water 4.0 module, making sure to provide strain relief for the cable. Be sure to

securely fashion the cable by using the cable tie, as illustrated in the next figure.

Preliminary