User's Manual
Table Of Contents
- Introduction
- Product Description
- Operating Instructions
- Outputs
- Testing
- Installation and Removal
- Glossary
- Display
- Nameplate Information
- Wiring Diagrams
- Technical Specifications
3UHOLPLQDU\
Contact Elster Electricity for information
07 April 2006 v
REX Meter
Technical Manual Contents
FCC and
Industry Canada
Compliance
Compliance Statement (Part 15.19)
The REX meter complies with Part 15 of the FCC Rules and with RSS-210 of
Industry Canada. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation
Warning (Part 15.21)
Changes or modifications not expressly approved by Elster Electricity, LLC could
void the user’s authority to operate the equipment.
RF Radiation Safety Guidelines per Part 2 of FCC Rules
and Regulations
The meter should be installed in a location where there will be a separation
greater than 20 cm from locations occupied by humans on other than an
incidental or transitory basis.
User Information
The REX meter has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
the user is encouraged to try to correct the interference by one or more of the
following measures:
■ Reorient or relocate the receiving antenna.
■ Move the receiving equipment farther away from the REX meter.
■ Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Statement
The term “IC” before the certification/registration number only signifies that the
Industry Canada technical specification were met.
Technical
Manual
REX
Meter