User's Manual

Chapter 4 Operation

Route Scan Sub-menu (key 5)

To view detailed transponder information not available with other menus, the Route Scan

menu may be used. Information such as read status, meter reading, street address, and

location are displayed. If the transponder has not yet been read, then the Lat/Lon

coordinates that are displayed are those which were read from the floppy disk. If the

transponder has a good read status, then the location of the MMI where the read was

obtained will be displayed as that transponders Lat/Lon. Upon entering the Route Scan

menu, the user is prompted for an ID number. At this point, the user must enter the serial

number of the desired transponder followed by the Enter key. Leading zeros in the entry

are not required. Once the current display is complete, the user may either choose a new

transponder to search for, or return to the main menu. Figure 10 shows a sample Route

Scan menu display.

Figure 10. Route Scan Sub-menu Display

Backup Memory Menu (key 7)

The Backup Memory menu allows the user to view and retrieve all the data stored in the

battery backed-up memory. This data may either be the data for the current route, or the

data for previously used routes. Figure 11 shows the menus available within the Backup

Memory menu. The backup memory can store a maximum of 30,000 transponders or 30

routes, and each route may contain up to 10,000 transponders. A discussion of each

Backup Memory menu is described below:

Id .................... 2789324

Status .............. ( 10 ) Unint

Reading ........... 0

Address ........... 1305 Philmont Ave.

Latitude ........... 72.49987

Longitude ........ 38.20110

The distance to the MMI is : 407.23 feet

BACK

MAIN

ANOTHR