User's Manual

Chapter 4 Operation
Option 2: This selects whether the MMI will beep after each good reading. The
options are YES and NO.
Option 3: This selects whether the MMI will attempt to reset a tamper indication
after it performs a reading. The options are YES and NO.
Option 4: This option allows the user to set the interrogation window size. When
selected, the user must key in a new value, followed by the Enter key. The
value entered must be the desired window size divided by 100. Valid
ranges are 1-99.
Example: If a window size of 1500 feet is desired, enter 1 5.
Option 5: Enabling this option allows the user to sort the unread display
in order of increasing distance from the MMI.
Option 6: This option allows the Dynamic Window to be turned on and off. The
options are YES and NO.
Option 7: This option determines whether or not transponder replies containing
a meter reading checksum error will be allowed. Caution! Any meter
reading information from a transponder with such a status should not
be trusted! The options are YES and NO.
Option 8: This option allows the Self-navigation mode to be turned on and off.
The options are YES and NO.
Option 9: This option is used to set the minimum signal level that is required
to accept a reply from an uninitialized transponder in GEO mode.
Valid ranges are 0-255.
Enter: Press this key to exit, and use any new settings.
‘Q’ key: Press this key to exit, and abandon all changes.