User's Manual

Chapter 4 Operation

The Summary command menus display information in the format shown in Figure 6.

When the operator selects a particular Summary command menu, the MMI searches the

route for only those transponders that have responded accordingly.

Figure 6. Summary Display Data Format

The six menus of the Summary command detail the various possible states for the

transponders in the route. This serves to give a quick, detailed look at the progress being

made in the reading of the route. The definition of each Summary command menu and

associated transponder states are discussed below:

All All transponders in the route will be displayed.

Unrd Any unread transponders in the route will be displayed.

Unint Any transponders that have never been polled will be displayed.

Reminder: The MMI will not poll a transponder until it is in the

interrogation window while in the Lat/Lon or GEO mode of reading,

or unless it has not Lat/Lon coordinate, and GEO mode is active.

Good Those transponders that have been successfully read, including tampered units,

will be displayed. Refer to Table 1 for a summary of transponder status

definitions.

Tmpr Any transponders which have returned a tamper status will be displayed.

Inwin In the Lat/Lon mode of reading, all transponders which are in range of the MMI

read window and are displayed. In the FIFO mode of reading, all unread

transponders will be displayed as being in the window.

Summary Entry # Address SN # Status Reading

1 2804 Weber St. 2789321 G_NT 3749

2 12806 Weber St. 2930587 G_NT 9712

3 1474 Main St. 2002189 G_NT 7834

4 1795 North Main St. 2501987 G_NT 0328

UP DOWN QUIT HELP