User's Manual
Table Of Contents
- Contents
- Introduction
- Preparation and installation
- Quick Start Guide
- Controls and indicators
- Operating the EA_Mobile
- Reading mode
- Command mode
- Troubleshooting the EA_Mobile
- GUI buttons
EA Mobile User Guide
7. Command mode
81
Figure 7-17.
• Use the keypad to enter a new UID and LAN ID.
• Press the Send UID & LAN ID button to have the transceiver request the
specified endpoint to start sending message count data.
The message count data includes: transmitted messages, good messages
received, bad messages received, wake-up tones received, wake-up tones
tried, and percent good.
• Press the Reset Counts button to reset the counts to zero.
The figure below (Figure 7-18) is an example of the Reset Counts command
processing.