User's Manual

EA Mobile User Guide
7. Command mode
78
Figure 7-15.
The top portion of the screen displays the sequential summary Entry number,
endpoint/meter street Address, endpoint Serial Number, endpoint Status and
meter Reading.
Note: For the UnRead button, the Reading column is replaced with a
Distance column.
The All number indicates the number of endpoint/entries in the selected category.
In the case of the display example shown above, there are a total of 4500 entries,
only 28 of which can be seen at this time.
The bottom of the screen displays the following three buttons:
• UP - scrolls to the previous window
• DOWN - scrolls to the next window
• Close - exits the screen and returns to the Summary window.
Endpoint status codes
The following table lists the endpoint status codes and their definitions for gas
and water endpoint. For electricity endpoints, a HEX value will be displayed
indicating status. These status Output Codes are used in the VAN file only. Various
screens on the LCD touch screen monitor use text mnemonics for some of the
same indications.
In the table below:
• Status Code reflects various combinations of conditions including:
interrogated/uninterrogated, good/bad/no read, tamper evidence, tamper
reset succeeded/failed/pending and bad checksum (data integrity checks)
on meter reading, serial number or both.
• Simple description describes the abbreviations used in the Status Code
column.