User's Manual

EA Mobile User Guide
2. Preparation and installation
23
9. Connect EA_Mobile power:
a. Align the 2 connector holes, slotted side up, with the 2 receptacle pins on
the EA_Mobile back panel (Figure 2-6) and turn screw-type connector
until finger tight.
b. Firmly insert the other end of the power cable into the vehicle’s accessory/
cigarette lighter receptacle and push until snug.
Warning: If using the EA_VID option, you must use a separate car
accessory sockets to power the EA_VID and utilize the
EA_Mobile direct battery connect cable (Part #:52860G050) to
power the EA_Mobile. Any other means of powering the
EA_VID and EA_Mobile units may result in product and/or
vehicle damage and may void product warranties.
10.Secure the EA_Mobile in the vehicle so as to prevent accidental movement.
Standard seat-belts and custom-designed mounting harnesses or brackets
may be part of a system used for properly restraining the EA_Mobile in a
given vehicle.
Caution: Failure to secure the EA_Mobile in the vehicle may result in
injury to occupants and/or damage to vehicle or EA_Mobile in
the event of an accident or abrupt vehicle movement. The user
is responsible for providing a system appropriate to each
vehicle used that ensures the safety and protection of persons
and equipment in that vehicle.
The EA_Mobile is now properly set up and ready to receive a route. See Chapter
3, “Quick Start Guide” and Chapter 5, “Operating the EA_Mobile” for operating
instructions.