User's Manual

EA Mobile User Guide
2. Preparation and installation
22
5. Route both antenna coaxial cables to the inside of the vehicle, preferably
from the passenger side.
Caution: Ensure routing method secures cables without crimping or
crushing and provides proper safety for occupants and
equipment.
6. Mount the GPS receiver on the front right for a van or the back middle for a
truck:
a. Attach the GPS receiver to the roof using the magnetic mount on the flat
(bottom) side of the receiver.
b. For optimal satellite reception, mount the receiver with the flat side down
and as nearly horizontal as possible.
c. To minimize interference to and from antennas, mount GPS at least 2 to 3
feet away from antennas.
7. Route the GPS receiver cable to the inside of the vehicle.
Caution: Ensure cable routing method secures cable without crimping or
crushing and provides proper safety for occupants and
equipment.
Figure 2-6.
8. Connect the antennas and GPS receiver cables to the EA_Mobile (see Figure
2-6):
a. Connect transmitter antenna to the TRANSMITTER receptacle on the
EA_Mobile back panel by turning the screw-type connector until finger-
tight.
b. Connect the Transceiver antenna to toe EnergyAxis receptacle on the
EA_Mobile back panel by aligning the pin and pushing the coax
connector on and twisting it ¼ turn until locked in placed.
c. Connect the GPS receiver by aligning the 4 connector holes, slotted side
up, with the 4 GPS receptacle pins on the EA_Mobile back panel and turn
screw-type connector until finger tight.
Warning: Do not block air flow to the EA_Mobile cooling fan located on
the back panel to the left of the power connector.