User's Manual

EA Mobile User Guide
2. Preparation and installation
17
EA_Mobile unpacking and set-up will take about five minutes using the
procedure described below. No special tools are required.
Received equipment inventory
The EA_Mobile is shipped with the following components inside its case:
• Interrogator unit (transceiver, CPU, USB flash drive, etc.)
• EA_Mobile-to-vehicle power cable and connector
• GPS receiver, cable and connector
• Transmit antenna, cable and connector
• EnergyAxis transceiver antenna, cable and connector
• 7 inch LCD touch screen and connector cables
Note: The optional EA_VID is shipped separately.
Unpacking the EA_Mobile
The EA_Mobile wheeled carrying case contains all the basic EA_Mobile
equipment and materials listed above.
1. Set the carrying case on a sturdy flat surface with the wheels and sliding tow
handle on the bottom.
2. Remove any locks that may have been attached for security purposes.
3. Release both latches and open the case.
4. Remove the handheld touch screen from the top of the EA_Mobile unit.
5. Remove the cables and antennas from beside the EA_Mobile.
6. Lift the EA_Mobile unit from the case and remove the packing wrap.
7. Leave packing materials in the case for future use and stow the case in a
secure location.
Antennas
Antennas are fully assembled and can not be disassembled
Caution: Attempting to disassemble antennas with black Mag from
mount bases will cause damage to the antennas and possibly
to the EA_Mobile.
EnergyAxis transceiver (RX) antenna
Screw-in BNC connector.
Transmit (TX) antenna
Screw-in N connector.
Installing the EA_Mobile This section describes the procedure for installing the EA_Mobile and
components in the selected vehicle.