User Manual

Page ii EnergyAxis Gas Module ― User Guide
Elster Integrated Solutions • Draft Rev A Nov. 2007
FCC & Industry Canada Compliance
EnergyAxis Gas Module™ has been granted authorization as a low power
modular radio transmitter by the Federal Communications Commission
under 47 CFR Part 15.247 and by Industry Canada under RSS-GEN and
RSS-210. FCC ID: G8JEAGAS01. Industry Canada ID: 3599-EAGAS01.
The device transmits and receives in the frequency range 902.8 – 927.6
MHz. The device may also receive on 451.35 MHz.
The user of this device must maintain a distance of 20cm between the
device and any part of the human body, to comply with FCC RF exposure
requirements.
This device complies with FCC Part 15 & Industry Canada RSS-GEN/RSS-
210 rules. Operation is subject to the following conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates uses and radiates radio frequency energy, and if
not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation distance between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected (not applicable for the battery-powered
EnergyAxis Gas Module™).
• Consult the equipment dealer or an experienced radio/TV technician
for help.
WARNING! Changes or modifications not expressly approved by Elster
Integrated Solutions void the user’s authority to operate the
equipment.