User Manual

APPENDIX

Page 22 EnergyAxis Gas Module ― User Guide

Elster Integrated Solutions • Draft A Nov. 2007

Identifying the Components (Meter Mount)

Each shipment of EnergyAxis RGTs includes all the hardware

necessary to successfully install a transponder onto a meter.

You will receive:

• The meter-mount transponder

• A 5-ft /10-ft meter pulser board connected to the transponder by

a standard one-foot cable.

CAUTION: Use extreme care transporting and installing the

pulser board. The glass reed switches are extremely fragile.

Keep the protective bubble wrap on the pulser board until

installation.

• Six (6) plastic spacers (2 short, 2 tall/fat post, 2 tall/thin post) to

position the pulser board on the index

• Meter mounting kit (2 brackets with 2 hex-head slide screws

and 2 Phillips-head screws)

Meter-mounting hardware can also be purchased separately. See

table below for part numbers.

To Order Additional Meter-mount Hardware

Item Part Number

Meter Mounting Kit (2 brackets, 2 mounting

screws, 2 hex slide screws)

52805K004

Pulser Mounting Kit (6 spacers) 52807K003

* Part numbers are subject to change. Be sure to include item description when ordering.

American

Meter 5/10 ft.

Pulser board

Mounting kit with:

• brackets (2)

• slide screws (2)

• mounting screws (2)

Spacers (6)

Meter-mount

remote VRT

gas

trans

onde