User`s guide

89
NVIDIA Corporation
C
HAPTER
9 QuadroView And AutoCAD
Animation Options
Figure 9.4
QuadroView Animation Toolbar in AutoCAD
In AutoCAD, you can define, hide, and remove the splines for an animation
inside the Viewer by using the options in the toolbar.
The options in Table 9.5 are also available from inside the QuadroView viewer;
see “Animation Toolbar” on page 50.
Table 9.5
QuadroView Animation Options in AutoCAD
Option Description
NVSELANIMPATHS Use this option to define the spline for the Camera Path
and the spline (if any) for the LookAt Path.
• When you start the command, you are asked to
select a spline to be the Camera Path.
• If a Camera Path already exists, you can skip
selecting the Camera Path and keep the current one.
• You can define the LookAt Path in the same way.
• If you do not want a LookAt Path, right click or
press ESC or ENTER to end the command.
Note: If Animation Paths were already defined, the
animation data will be deleted and the new paths will
define an animation with default settings.
NVSELLOOKATPATH Defines a path to be the LookAt Path. A Camera Path
must already exist. Use this command to select only a
LookAt Path without changing the Camera Path.
NVTOGCAMPATH Toggles visibility of the Camera Path.
NVTOGLOOKATPATH Toggles visibility of the LookAt Path. Use this
command to switch the Camera Path (if any), visible or
invisible.
Use this command to switch the LookAt Path
(if any), visible or invisible
NVDELCAMPATH Deletes animation data for the Camera and LookAt
Path.
NVDELLOOKATPATH Deletes animation data for the LookAt Path.
BKNVRelQV_oem.book Page 89 Friday, April 19, 2002 2:43 AM