User Manual

36
Note: If you find Monitor Center is not working properly,
please check the telephone no. and Unit ID no. you
enter are correct.
REMOTE TEL CONTROL SETUP
Scroll through the manual until ‘4-3 Remote TEL
Control Setup’ is displayed and press .
After completing the Remote TEL Control Setup
press to return to the top level programming
menu.
Key
on the
phone
Type of setting Result
º 1
Full arm Begin
º 2
Partial arm Begin
º 3
Holiday arm Begin
º 4
Disarm Begin
º 5
Turn off all of green control Begin
º 6
Siren off Begin
º 7
Siren on Begin
º 8
Listen In (see Note)
Begin
º 9
Read the status of Smart Home Box Begin
º 0
Read the status of AC power supply Begin
º＃
Hang up the phone End
Redial
the call
NO
Waiting
Timeout
Hang up
the phone
Event Trigger
Dial Preset
TEL No.
Send trigger
message to
monitor center
More
Messages?
YES
YES
End
YES
NO
NO
Call Routing Sequence
(Monitor Center)
En
d
Enter User
Password
successful
Over 3
times
YES
NO
Enter Remote
TEL Control
YES
Smart Home Box
a. answers the call &
emits three beeps
b. alarm dial successful
Hang up
the phone
Flow Chart for Remote TEL Control
NO
YES
KEY process
KEY =‘º’
Timeout
5 seconds
Wait to enter
KEY, 5 Sec
KE
Y
KEY = ‘0’~’9’, ‘º’
YES
Begin
Timeout
30 seconds
Hang up
the phone
End
Wait to enter ‘º’
30 Sec
KEY=’＃’
Flow Chart for Control
See Table 1
Note:
Press º and then 8 on the phone to enter listen-in state to monitor
what is happening in the protected property of which timeout is 5
minutes.