USERS MANUAL Owner's manual

-23--42-
User Setup
Password Admin: 1234
User 1~5: Not
Programmed
Name Admin. User 1~5
Tel Remote Admin: ON
User 1~5: OFF
Record User
Message Not Programmed
Replay User
Message Not Programmed
Remoter Not Programmed
System Setup
Alarm Time 180s
Internal Siren ON
External Siren ON
Auto Report ON 12h
RF Jamming Detection OFF
Back Light 10s
Error Beep OFF, 30s
Alarm Relay ON until Disarm
Call Abort OFF
Key Tone ON
GSM Dialer OFF
Dialer Mode Voice
Wirefree Siren ON
Wirefree Keypad OFF
Zone Lock ON
Zone Setup (1-36)
Name No Name
Type Intruder
Chime Mode OFF
Entry Delay
Zone 1-36 OFF, 30s
Partial Arm 1 OFF
Partial Arm 2 OFF
Magnetic O/C Detector ON
Auto Report ON
Zone Status OFF
Zone Reset Not Programmed
Zone Siren ON
Telephone Setup / Voice Dialer
Phone Numbers Not programmed
Record Voice Not Programmed
Play Voice Not Programmed
Alarm Dial All numbers
disabled
Tel Confirm Times 1
Dial Round 3
Play Time 70s
DEFAULT SETTINGS
Default setting: 1
Scroll through the menu until ‘:5 TEL Confirm’ is displayed. The current
settings will also be displayed.
To change the setting press .
Enter the required number (1-6).
Press to save and exit, or
Press to exit without saving.
DIAL ROUND
This sets the maximum number of times that the dialer will attempt to contact
each enabled telephone number in the call routing sequence.
Default setting: 3
Scroll through the menu until ‘:6 Dial Round’ is displayed. The current setting
will also be displayed.
To change the setting press .
Enter the required number (1-9).
Press to save and exit, or
Press to exit without saving.
ALARM MESSAGE PLAY TIME
This is the total time for which the alarm messages will be played & repeated
when a call made by the voice dialer is answered.
Default setting: 70s
Scroll through the menu until ‘:7 Play Time’ is displayed. The current setting
will also be displayed.
To change the setting press .
Scroll through the available options, (50, 70, 90 and 110s) until the required
setting is displayed.
Press to save and exit, or
Press to exit without saving.
Telephone setup/ digital dialer.
Phone Not Programmed
Unit ID No. Not Programmed
Call Attempts 3
Open/Close by
User OFF
Telephone setup/remote telephone
control
Remote Telephone
Control OFF
Remote Type One Call
One Call Ring Ring 6
Double Call Time 13s
Dial Method DTMF
Fully arm setup
Exit Delay ON, 30s
Entry Delay Beep ON
Exit Delay Beep ON
Partial arm 1 setup
Exit Delay ON, 30s
Entry Delay Beep ON
Exit Delay Beep ON
Partial arm 2 setup
Exit Delay ON, 30s
Entry Delay Beep ON
Exit Delay Beep ON
Time & date setup
Date 01/01/05 Sat.
Time 12:00:00
Latchkey setup
Set Latch Key All OFF
Set Partial User OFF
Set Latch Key
Tel Number Not Programmed
ENEN