Installation manual

105U-L Wireless I/O Installation Manual
105U-L Wireless I/O Page 33 of 38
Version 1.9
Configuring your units
You can configure your network using:
 Default factory configuration – that lets you easily setup your network as a simple
send/receive; or
 User-defined customized configuration – that lets you set specific information
about your network and allows communication with other ELPRO 105 series devices.
For more information on setting a user-defined customised configuration, see the User
Manual.
For more information on setting the factory default configuration, refer to the Quick Start
Guide included with your module.
The following table details the factory default configuration:
Signals sent over radio
105U-L-T(Transmitter) Sends 105U-L-R (Receiver)
Digital Input 1

Digital Output 1
Digital Input 2

Digital Output 2
Analog Setpoint

Digital Output 3
Analog input (4-20 mA)

Analog output
Other signals
105U-L-T(Transmitter) 105U-L-R (Receiver)
Thermocouple Input (Not used) Communication Failure
(Comes on if no messages from 105U-L-T)
Setpoint Output (Local indication)
System OK (On if system OK) System OK
(On if system OK)