Installation manual

105U-L Wireless I/O Installation Manual
105U-L Wireless I/O Page 28 of 38
Version 1.9
Pulse input
The 105U-L-T module lets you configure the digital inputs as pulse inputs with the
following characteristics:
Characteristic Value
Maximum rate
10 Hz
Minimum off time
20 mSec
Minimum on time
20 mSec
Using this mode, you can map the pulse count to a remote output by transmitting the
pulse count to a 105-G module register or re-generating as a Pulse Output on 105-1 or
Digital Output on a 105-3 unit.
Note
You should connect the pulse input in the same way as a digital input.
The following diagrams illustrate different connection methods:
Connection
method
Example
Passive
transistor
Active pulse
device